Programming Instructions for 1998 Toyota Avalon Remote Fob
Have all transmitters for the vehicle at hand1. Make sure all doors are closed
2. Open Driver's door
3. Insert key into ignition, then remove it
4. Press LOCK and UNLOCK on the vehicle door lock switch at 1 second intervals 5 times.
5. Close and re-open driver's door
6. Press LOCK and UNLOCK on the vehicle door lock switch at 1 second intervals 5 times.
7. Insert key into ignition switch
8. Turn the ignition to ON then back to OFF (Do NOT Start or crank engine).
9. Remove Key from ignition
10. Door locks should cycle to confirm entry into programming mode
Press LOCK on remote for a minimum of 1 second
11. Locks should cycle once to confirm programming. If they cycle twice, the programming failed
12. Repeat button procedure to program remaining remotes
13. Close driver's door. Test remotes.
Key Programming Information for 1998 Toyota Avalon
Have your master Toyota key at hand (black key)1. Insert black programmed key into ignition.
2. Press and release accelerator pedal 5 times within 15 seconds of inserting key into ignition.
3. Press and release brake pedal 6 times within 20 seconds of step 2.
4. Remove black key from ignition switch.
5. Insert new unprogrammed key into ignition within 10 seconds of step 4.
6. Press and release accelerator pedal once within 10 seconds of step 5.
7. Once these steps are performed properly you will see the immobilizer warning lamp begin to flash and after one
minute the lamp will stop flashing. Once the immobilizer warning lamp stops flashing you will have ten seconds to insert an additional key to be programmed.
8. Within ten seconds of inserting key into ignition press and release accelerator pedal once.
9. Immobilizer warning lamp will flash and after one minute the lamp will shut off.
Use our Locksmith Search if you need professional help.