How to Program a 2008 GMC Savana Keyless Entry Remote Fob
Step by Step How to Program Instructions:Use this Procedure for Vehicles with Driver Information Center Buttons
1.Insert Key and turn to ONposition so you can access Driver Information Center
2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the first keyless remote at the same time forapproximately 15 seconds. A chime will sound indicating that the remote is programmed.
5. To program additional remotes at this time repeat step3. This vehicle can have a maximum ofeight remotes programmed.
6. To exit programming mode turn key off and remove key. Test remote(s).
Use this Procedure for Vehicleswithout Drivers Information Center Buttons
To access this display, the vehicle must be in Park (P) with key in theon position (as far as you can go without cranking engine.
1. Press the trip odometer reset stem untilRELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for threeseconds. The message REMOTE KEY LEARNING ACTIVE will display
3. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
4. To program additional remotes at this time repeat step3. This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key off and remove key. Test remote(s)
Use our Locksmith Search if you need professional help.